Connecting to a Device Using Beam
  • 20 Jan 2023
  • 1 Minute to read
  • Dark
    Light
  • PDF

Connecting to a Device Using Beam

  • Dark
    Light
  • PDF

Article summary

Once a device has the Beam client installed and running, it will now show up in the ‘Devices’ table on the Beam Group page. You can search the connected devices by the device’s name, domain, local IP or remote IP.

In order to connect to a device, click the ‘Connect To Device’ button and a modal will open up. Inside this modal, you will have to fill out the credentials that correspond to the device’s authentication method. You can also choose whether or not to record the Beam session. Below are examples of the modal depending on which authentication method the device has chosen.

If the credentials are valid and the device is ready, you will see the modal change to the picture below :


You can also close the modal by clicking the little ‘X’ in the top right corner, after which you can still enter the session. The ‘Connect to Device’ button will change to a ‘Enter Session’ button, shown below.




Was this article helpful?